WarmRite Floor Warming Control Panel (Top Entry)

This WarmRite Floor Warming Control Panel is designed to operate floor warming and basic heating systems. This panel incorporates non-ferrous components to allow use with the domestic water supply where permitted.

A built-in tempering valve allows control of supply water temperature. The panel is operated as a single zone system by using the thermostat to activate the circulator.

(With optional Actuators)

The WarmRite Floor Warming Control Panel can be operated as a multiple zone system. The on/off valves located on the return manifold are fitted with optional electrical valve actuators to control individual loops in the system. In this application the actuator (or actuators) can be connected to a thermostat located in the area served by the loop (or loops). If periodic circulation to avoid stagnation is required, the circulator control module will exercise the pump and all zones.

NOTE: Ensure that the thermostat is capable of handling the amperage draw from the actuator (check manufacturer specifications).

NOTE: Pumps are provided based on the number of loops in the control panel. There are times the standard pump in the control panel may not be appropriate for the application, and in those cases, the customer can order a custom control panel which has the appropriate pump based on flow rates and pressure drops for the project.

Balancing valves on the supply manifold with flow indicators on the return manifold allow the user to adjust and visually monitor the flow rate of each loop. The circulator module contains a 24V transformer, a circulator relay, a dry contact enable, and an adjustable high/low limit that prevents the supply water from exceeding the desired temperature. Valves on both the supply and return manifolds allow for isolation of the loop when necessary.

The WarmRite Floor Warming Control Panel is controlled by a 24V dry contact. The panel may be controlled by devices such as: two and three wire room thermostats, set point controls, indoor/outdoor reset controls, integrated building controls, etc.

Features:

• Accommodates 1-5 loop systems
• Supply manifold with balancing valves
• Return manifold with on/off valves and flow control indicators
• Tempering valve
• Circulator control module (includes 24V transformer, circulator relay, dry contact enable, and high limit) and execisor
• Circulator (non-ferrous)
• Temperature gauges
• Fill / drain valve
• Isolating valves
• Steel Cabinet
• Fittings must be ordered separately from a choice of 3/8", 1/2", 5/8", 3/4" XPA or PEX. Thermostat is not included.
• Kitec General Help
• Kitec shipping / availability guidelines

Note: Quantities can be modified after you "Add to Cart". The shopping cart will also give you a running total of the shipping charges.