WarmRite Snowmelt / Manifold Station with Circulator

This panel is designed as a basic manifold station, there is no supply water temperature control in the panel.

The panel is operated as a single zone system by using a thermostat to activate the circulator.

The panel can also be used as a multiple zone system. The on/off valves located on the return manifold can be fitted with optional electrical valve actuators to control individual loops in the system. In this application, every actuator is connected to a thermostat located in the area served by the loop(s) when the thermostat calls for heat, the actuator(s) opens the loop(s) allowing flow. When all loops are satisfied the circulator is shut down.

Note: Ensure that the thermostat is capable of handling the amperage draw from the actuators (check manufacturers specifications).

Balancing valves located on the supply manifold with flow indicators on the return manifold allow the user to adjust and visually monitor the flow rates of each loop. The circulator control module contains a 24V transformer, a circulator relay, a dry contact enable and an adjustable high/low limit which prevents the supply fluid from exceeding the desire temperature. Valves on the supply manifolds allow each loop to be isolated when necessary. The optional actuators and thermostats must be ordered separately according to the project specifications.

The panel operation is controlled by closure of a 24V dry contact. An example of devices that can provide this are: two and three wire room thermostats, programmable thermostats, set point controls, indoor/outdoor reset controls, integrated building controls, etc.

Note: Pumps are provided based on the number of loops in the control panel. There are times the standard pump in the control panel may not be appropriate for the application and in those cases, the customer can order a custom control panel which has the appropriate pump based on flow rates and pressure drops for the project.

Features:

• 5, 8 and 14 loop control panels allowing 3-14 loop systems
• Supply manifold with balancing valves
• Return manifold with manual shut off valves and flow rate indicators
• Circulator control module (includes 24V transformer, circulator relay, dry contact enable, and high limit)
• Circulator
• Pressure and temperature gauges
• Fill / drain valves
• Automatic air vent
• Isolating valves
• Steel Cabinet
• Fittings must be ordered separately from a choice of 3/8", 1/2", 5/8", 3/4" XPA or PEX. Thermostat is not included.
• Kitec General Help
• Kitec shipping / availability guidelines

Note: Quantities can be modified after you "Add to Cart". The shopping cart will also give you a running total of the shipping charges.