WarmRite Control Panel with Heat Exchanger

This panel is designed to separate the secondary system fluid from the primary system fluid by utilizing a plate heat exchanger, and is recommended for applications that use an open loop system as the heat source or in applications where a water/glycol mixture is used in the secondary heating loop.

The secondary system is filled during installation and operates as a closed loop circuit. The panel comes with an expansion tank and relief valve for the secondary side of the system. There is no supply water temperature control provided. Options are available such as themostatic mixing valves, motorized mixing valves and injection mixing.

The panel is operated as a single zone system by using a thermostat to activate the primary circulator. The secondary circulator operates continuously providing even heat distribution during cool down cycles. The secondary circulator can be operated on a demand for heat with the primary circulator.

The panel can also be operated as a multiple zone system. The on/off valves located on the return manifold can be fitted with optional electrical valve actuators to control individual loops in the system. In this application, every actuator is connected to a thermostat located in the area served by the loop. When the thermostat calls for heat, the actuator opens the loop allowing flow. When all loops are satisfied, the primary circulator is shut down.

The panel operation is controlled by closure of a 24V dry contact. An example of devices that can provide this are: two and three wire room thermostats, programmable thermostats, set point controls, indoor/outdoor reset controls, integrated building controls, etc.

Features:

• 4, 6 and 9 loop control panels allowing 3-9 loop systems
• Supply manifold with balancing valves
• Return manifold with manual shut off valves and flow rate indicators
• Circulator control module (includes 24V transformer, circulator relay, dry contact enable, and high limit)
• Primary circulator (stainless steel)
• Secondary circulator
• Expansion tank for secondary circuit
• Plate heat exchanger
• Pressure and temperature gauges
• Fill / drain valves for secondary circuit
• Pressure relief valve for secondary circuit
• Automatic air vent for secondary circuit
• Manual air vent for primary circuit
• Isolating valves
• Steel Cabinet
• Fittings must be ordered separately from a choice of 3/8", 1/2", 5/8", 3/4" XPA or PEX. Thermostat is not included.
• Kitec General Help
• Kitec shipping / availability guidelines

Note: Quantities can be modified after you "Add to Cart". The shopping cart will also give you a running total of the shipping charges.